Not suitable for cars with dpf filter. If you need to drive camshaft with dpf filter, email us before buying. Hydraulic tappets (hard type) x8 parts.
Mounting instructions shaft motor parts has cams. Verify that the new camshaft is identical to the old camshaft, particularly regarding the oil passages. Make sure the pads of the camshaft are not worn or damaged from excessive way.
Check that the valve seats of valves, LIQUIDS, springs and seals tightness of the valve stems are in good condition. Distribution Gears and distribution chains should be examined to detect any wear.Replacement or machining must be performed in accordance with needs. The timing belts should be replaced always when installing a new camshaft.
On the new camshaft, check that the oil passages are clean and not clogged. Remove completely while preserving agent of all contact surfaces, taking care not to damage the pads or contact faces. New rollers cam / push rod has to be mounted. This is very important in order to avoid a premature wear of the camshaft.Claims will be invalidated if this operation is not performed. Grease thoroughly all the cam bearings and lobes of the camshaft with pre-lube or engine oil of good quality. The shaft end play has cams must be verified and settled in accordance with the workshop manual of the engine manufacturer. Fill crankcase with new oil and install a new oil filter. Finally, a push rod must be audited and rules correctly. This operation must be repeated after a journey of 800 kms. If you broke the cam shaft again then it suitable there. \The seller is \This article can be shipped worldwide.